giftcrm.blogg.se - Synology drive tray key

Connect one end of the AC power cord to the AC power adapter, and the other to the power outlet.Ĭongratulations! Your DiskStation is now online and detectable from a network computer.Īdd more Memory to your DS718+ NAS DiskStation Use the LAN cable to connect the DiskStation to your switch, router or hub.Ģ. Connect the AC adapter to the power port of the DiskStation. Be warned, if you want to create a RAID volume, we recommend that all installed drives are of the same size to make the best use of drive capacityġ. Turn the tray upside down and tighten the screws to secure the drive in place.Ĥ. Insert the loaded hard drive tray into the empty hard drive bayĥ. Press the handle in flush with the front panel to hold the hard drive tray in place.Ħ. Insert the hard drive tray key into the hard drive tray lock, turn the key clockwise (to the “I” position) to lock the handle of the hard drive tray, and then remove the key.ħ. Repeat the steps above to assemble the other drives you have prepared. Place the drive in the blue area (shown below) of the drive tray. Ii) For 2.5” drives: Remove the fastening panels from the sides of the drive tray and store them in a safe place. Then insert the fastening panels to secure the drive in place. I) For 3.5” drives: Remove the fastening panels from the sides of the drive tray. Press the lower part of the hard drive tray to pop out the handle.Ģ. Pull the hard drive tray handle in the direction as indicated below to remove the hard drive tray.

At least one 3.5” or 2.5” SATA drive (Ideally WD Red or Seagate Ironwolf)ġ.

Two G.R.A.S.Before setting up your new DiskStation, please check the package contents to verify that you have received the items below.Īlso, make sure to read the safety instructions carefully to avoid harming yourself or damaging your DiskStation.Ĭhapter 2: Hardware Setup of your Synology DS718+ NAS Tools and Parts for Drive Installation

Noise Level Testing Environment: Fully loaded with WD 1TB WD10JFCX hard drive(s) in the idle state.

Power consumption is measured when it is fully loaded with Western Digital 1TB WD10JFCX hard drive(s).

Each internal volume (may consist of multiple drives) is expandable up to 108TB.Ģ (with Link Aggregation / Failover support)ĮxFAT Access is purchased separately in Package Center.īrightness Adjustable Front LED Indicators.

This term does not indicate the maximum connection speed of each drive bay.

"Compatible drive type" indicates drives that have been tested to be compatible with Synology products.

Storage Pool and volume creation require all drives to be listed as compatible on the device model's compatibility list.

Rest assured that the compatibility and stability have been strictly verified with the same benchmark to ensure identical performance. Synology reserves the right to replace memory modules with the same or higher frequency based on supplier's product life cycle status.Synology will not provide complete product warranty or technical support if non-Synology memory modules are used for memory expansion.

Please select Synology memory modules for optimum compatibility and reliability.H.264 (AVC), H.265 (HEVC), MPEG-2 and VC-1 maximum resolution: 4K (4096 x 2160) maximum frame rate per second (FPS): 30